How to Change a Water Cooler Bottle

How to Change a Water Cooler Bottle

How to Change a Water Cooler Bottle

Changing a water cooler bottle is a simple task which can be completed within a minute or so. Unfortunately, most people are in such a rush and end up leaking the entire contents of the bottle down the front of them and ending up with a big soggy patch on the carpet.

Switch Off And Prepare The Unit

First, make sure you have switched off your water cooler. Next, empty the catch tray underneath your cooler and make sure it is sitting correctly to avoid any spillages. Before lifting the bottle out of the cooler, check the old bottle for any residue that may have stuck to the neck of the bottle. This can then drip down and cause a mess on the floor.

Lift The Old Bottle Safely

A full water cooler bottle is very heavy, so ensure you are bending at the knees and not at the back when lifting. If your water cooler has a slide-out cradle for the bottle then use this instead of trying to lift the whole bottle. Slide the bottle out slowly and place the empty bottle carefully to one side. Tip any remaining water from the empty bottle into a glass or the catch tray.

Check The New Bottle Before Fitting

Check the seal of the new bottle’s cap for any signs of tampering before fitting it. Then wipe it with a cloth. Hold the bottle up to the light to check the water is clear rather than cloudy and there are no signs of any cracks or damage to the bottle. This is especially important for offices in Wales which use bottled water cooler units. The bottles can be stored for long periods before use and so it is wise to follow the basic food hygiene standards for handling bottled drinking water for Wales as bacteria can quickly form on the cap and neck of a bottle if it is not kept clean. Water Coolers Wales is covered in more detail at https://www.waterforyou.net/.

Fit The Bottle In One Motion

Lift the new bottle and invert it over the cooler’s fill nozzle. Lower it down slowly to the fill nozzle in one smooth movement. This will help to prevent any air from entering the neck of the bottle. Once seated, the bottle should settle within a few seconds with a gentle thud.

Run Off The First Glass

Now run off a full glass from each tap (hot and cold) and check for any leaks around the base of the cooler. Running off clean properly managed water from your water cooler also complies with the consumer guidance on water quality and the supply of water, which explains what consumers can expect from any supply of drinking water whether this is from the mains or in bottles.

Store Spare Bottles Properly

Store your spare water bottles in an upright position in a cool place (avoid direct sunlight) and make sure you use the oldest bottle first to ensure the water stays fresh and tastes great. It’s also a good idea to check your spare water bottles from time to time for any signs of damage to ensure you’re never left without a bottle of water when you need it.

Follow these simple steps and soon you will be changing the water cooler bottle in five minutes or less!

Post Comment